Drive/propshaft assembly

Moderators: Steve 155C, Lashman, Keith Halstead

Drive/propshaft assembly

Postby midmillotus » Thu Jul 20, 2017 5:12 am

Am in the process of fitting the original 2-piece overhauled driveshaft back into my '67 car here in New Zealand after many decades out, but the manuals do not specify how much grease to use in the assembly of the centre splined grease chamber. Obviously there must be sufficient but not too much to compromise balance maybe? I guessing that filling the chamber and allowing excess grease to escape past the felt is not adviseable?
Any advice welcomed, cheers.
Learner Driver
Posts: 1
Joined: Thu Jul 13, 2017 5:15 am
LCR Membership Number: 0

Return to Open non-member section

Who is online

Users browsing this forum: No registered users and 2 guests